[Blabber] Ultimaker jam

David Reeves drreeves at gmail.com
Sun Oct 18 02:04:47 UTC 2015


You can do it at either end I think, but there might be a blue retaining
clip or wire that you need to remove first depending on which end you are
removing. Remember to put it back when you're done so that the tube is
secure.

On Sat, Oct 17, 2015 at 9:53 PM, Justin Levinson <localtalent at gmail.com>
wrote:

> Thanks! Is this at the extruder end or the nozzle end?
>
> On Sat, Oct 17, 2015 at 6:57 PM, David Reeves <drreeves at gmail.com> wrote:
>
>> If you push down on the collar around the end of the tube and pull the
>> tube gently at the same time it should come loose. Push collar down again
>> to reinsert tube once the filament is cleared.
>>
>> On Sat, Oct 17, 2015 at 6:48 PM, Justin Levinson <localtalent at gmail.com>
>> wrote:
>>
>>> The Ultimaker was out of commission when I came in this morning.  Turns
>>> out someone broke off a piece of filament and now it's trapped in the
>>> bowden cable - is there an easy mechanism to open the extruder and pull it
>>> out at that side or do I have to dismantle the nozzle?
>>>
>>> _______________________________________________
>>> Blabber mailing list Blabber at list.hackmanhattan.com
>>> https://list.hackmanhattan.com/listinfo/blabber
>>>
>>
>>
>> _______________________________________________
>> Blabber mailing list Blabber at list.hackmanhattan.com
>> https://list.hackmanhattan.com/listinfo/blabber
>>
>
>
> _______________________________________________
> Blabber mailing list Blabber at list.hackmanhattan.com
> https://list.hackmanhattan.com/listinfo/blabber
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://list.hackmanhattan.com/pipermail/blabber/attachments/20151017/90d34dac/attachment.html>


More information about the Blabber mailing list