[Blabber] Ultimaker jam

Justin Levinson localtalent at gmail.com
Sun Oct 18 01:53:35 UTC 2015


Thanks! Is this at the extruder end or the nozzle end?

On Sat, Oct 17, 2015 at 6:57 PM, David Reeves <drreeves at gmail.com> wrote:

> If you push down on the collar around the end of the tube and pull the
> tube gently at the same time it should come loose. Push collar down again
> to reinsert tube once the filament is cleared.
>
> On Sat, Oct 17, 2015 at 6:48 PM, Justin Levinson <localtalent at gmail.com>
> wrote:
>
>> The Ultimaker was out of commission when I came in this morning.  Turns
>> out someone broke off a piece of filament and now it's trapped in the
>> bowden cable - is there an easy mechanism to open the extruder and pull it
>> out at that side or do I have to dismantle the nozzle?
>>
>> _______________________________________________
>> Blabber mailing list Blabber at list.hackmanhattan.com
>> https://list.hackmanhattan.com/listinfo/blabber
>>
>
>
> _______________________________________________
> Blabber mailing list Blabber at list.hackmanhattan.com
> https://list.hackmanhattan.com/listinfo/blabber
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://list.hackmanhattan.com/pipermail/blabber/attachments/20151017/c093dd93/attachment.html>


More information about the Blabber mailing list