[Blabber] Tweet by johngineer

Guan Yang guan at yang.dk
Sun May 12 18:47:00 UTC 2013


Suppose you use 01005 resistors, and on the circuit board you need 4x as much space as the footprint of the resistors, then a 10k resistor can be made in just 2 square inches of board space.



On Sunday, May 12, 2013 at 14:44 , Robert Diamond wrote:

> But less than 10,000
> 
> On May 12, 2013, at 1:25 PM, Rendall Ren <rendall at gmail.com (mailto:rendall at gmail.com)> wrote:
> > That would mean you would need... at least... three!
> > 
> > 
> > On Sun, May 12, 2013 at 12:29 PM, Guan Yang <guan at yang.dk (mailto:guan at yang.dk)> wrote:
> > > Sage advice from an experienced electrical engineer.
> > > 
> > > John De Cristofaro (@johngineer (https://twitter.com/johngineer))
> > > 5/12/13, 11:44 (https://twitter.com/johngineer/status/333608713766203392)
> > > 
> > > Pro tip: if you need a 10k resistor, and you only have 1 ohm resistors, consider using them in series. 
> > > 
> > > 
> > > 
> > > 
> > > 
> > > 
> > > 
> > > 
> > > _______________________________________________
> > > Blabber mailing list Blabber at list.hackmanhattan.com (mailto:Blabber at list.hackmanhattan.com)
> > > http://list.hackmanhattan.com/mailman/listinfo/blabber
> > 
> > 
> > _______________________________________________
> > Blabber mailing list Blabber at list.hackmanhattan.com (mailto:Blabber at list.hackmanhattan.com)
> > http://list.hackmanhattan.com/mailman/listinfo/blabber
> 
> _______________________________________________
> Blabber mailing list Blabber at list.hackmanhattan.com (mailto:Blabber at list.hackmanhattan.com)
> http://list.hackmanhattan.com/mailman/listinfo/blabber





More information about the Blabber mailing list